How to connect the VTR adaptor to TV tuner

tools
10mm socket wrench
remover

Open the back door of the vehcle(Harrier or RX300)

Pull up the cargo mat of green area from the rear seat side.

(after peel of the mat)
Remove the black retainer.

Ref:　it is easy if you use the REMOVER or - driver.

Remove a bolt of Green Circle with 10mm socket wrench.

After you removed the 'bolts', you set up the rear seat again.
1. Pull the rear seat slider hook
2. Forward the rear seat with max point.
3. then fold the seat again.
you do same thing with right side, too.
important:) if you do not this, the access space is not appear enough.

(Picture from the rear cargo side)
there is the TV tuner box in the green circle, under the black frame.


(Picture from the rear seat side)
TV tuner box in the green circle.

You will see the white socket connected with TV tuner box.
Green circled space should be nothing to be connected.
You will connect here the VTR adaptor.

You should pass the cables under the carpet from where
you want to place the VTR adaptor input.

In Japan, most of users place FAN out of air conditioning
for rear seat.(center console), just below the AT shift bar,
or besides of front accessory socket.

(How to Place an adaptor Socket)
You should cut the plastic with cutter blade at squre
where you want to place.
If you do not want to cut your vehcle, please put, just
under the seat.

GOOD LUCK!!